SnowWolf 200W V1.5 Temp Control by Asmodus (Dual 18650)

ASM-SNW-BK
£49.96 (£41.63 Excl. Tax)
£99.95
You save: £49.99
Out of stock
Price in points: 4163 points
Reward points: 250 points
What Our Customers Say
Delivery
Payment Options
RedJuice Advantages

Rapid Order Turnaround

Order Status NotificationsWe will keep you updated at each stage of the delivery process by email.

Knowledgeable Customer Care

Buy With Confidence

Important: This device uses its two 18650 batteries in series and therefore you must use paired batteries, if you are in any doubt what this means please contact us before purchase.

The front and back panels are made of glass and can break as with any glass, this is not covered under warranty and is at your own risk.

Features

    1. Adjustable temperature control
    2. Low voltage protection
    3. Low resistance protection
    4. High input voltage warning
    5. Output short circuit protection
    6. Reverse battery protection
    7. Overheating prevention
    8. Variable wattage 5.0 - 200 watts
    9. Output voltage 0.5 - 7.0 volts
    10. Atomizer resistance 0.05 - 2.5 ohm
    11. Battery voltage 6.2 - 8.4 volts
    12. Temperature control range 100 - 350°C / 212 - 662°F
    13. Supports Kanthal and nickel wires
    14. Device Size 101mm x 51mm x 25mm

In The Box

    1. SnowWolf 200W V1.5 Temp Control by Asmodus (Dual 18650)

Using The Device

TURNING THE DEVICE ON:
Once batteries are installed, the device enters “turn-on mode” with the logo displayed, and will then enter into “lock mode” shortly after. Press the fire button 5 times consecutively within 3 seconds to unlock the device. After unlocking the device, atomizer resistance, output wattage, output voltage, battery level, and current regulated temperature will be displayed. Without an atomizer installed, the output voltage will read 0.00V and resistance will read 0.00Ω. If you attempt to fire without an atomizer installed, “CHECK ATOMIZER” will be displayed.

UNLOCKING THE DEVICE:
When the device is locked, pressing any button will show the message “LOCKED CLICK 5X”. When “LOCKED CLICK 5X” is displayed, press the fire button 5 times consecutively within 3 seconds to unlock the device. Your device is now ready to vape.

ADJUSTING THE WATTAGE:
If you would like to adjust the wattage, press both the “+” and “-” buttons simultaneously until the “W” in front of the wattage value is flashing. Now by pressing the “+” or “-” buttons you can increase or decrease the wattage respectively. The output wattage range is 5.0 to 200.0W. By pressing “+” below 50W, watts increase by 0.1 increment; above 50W, watts increase by 0.5 increments; above 100W, watts increase by 1 increment. By pressing “-”, below 50W, watts decrease by 0.1 increment; above 50W, watts decrease by 0.5 increments; above 100W, watts decrease by 1 increment. When wattage is higher than 150W, the system is pulse output and the upper right corner of the screen will display a "P" symbol.

ADJUSTING THE TEMPERATURE:
NOTE: Only when using pure nickel wires in your atomizer build will the temperature control function work. Ordinary wires can only make use of the watt adjustment function.
If you would like to adjust the temperature, press both the “+” and “-” buttons simultaneously until the “°C” or “°F” in front of the temperature value is flashing. Now by pressing the “+” or “-” buttons you can increase or decrease the temperature respectively. The temperature range is 100-350°C / 212-662°F. By pressing the “+” or “-”, temperature will increase or decrease by 1°C / 1°F. The system can switch between °C and °F by scrolling pass the minimum or maximum temperatures. (i.e. when you click “+” upwards to 662°F and continue to hold the button, it will automatically switch to 350°C; when you click “-“ downwards to 212°F and continue to hold the button, it will automatically switch to 100°C, and vice versa.)

TURNING THE DEVICE OFF:
When device is not in use, the screen will darken after 20 seconds. After 30 seconds the display will turn off and the device will enter standby mode. After 30 minutes in standby mode, device will automatically lock. Press the fire button 5 times in 3 seconds consecutively anytime during standby mode to turn off the device. “SYSTEM OFF” will then read on the display. Press any button to wake up the system.

BATTERY INFORMATION:
When battery voltage is lower than 6.2V, device will display “LOW BATTERY”. When battery power is low and does not match the current wattage or temperature setting, device will display ”CHECK BATTERY” and stop firing. When battery voltage is less than 5.4V, device will not power on; when this display appears, change batteries before use.

RESISTANCE RANGE:
This device supports only a resistance range from 0.05Ω - 2.5Ω, otherwise the device will not fire. When the resistance is lower than 0.05Ω, “LOW ATOMIZER” will be displayed and will not fire; when the resistance is higher than 2.5Ω, “HIGH ATOMIZER” will be displayed; when there is no atomizer, “CHECK ATOMIZER” will be displayed; when the atomizer shorts, “ATOMIZER SHORT” will be displayed.

ATOMIZER INSTALLATION AND DIS-ASSEMBLY:
If you remove the atomizer while the device is on and press the power button, “CHECK ATOMIZER” will be displayed. If you remove the atomizer while firing, “ATOMIZER REMOVE” will be displayed. When the device is on and you install an atomizer, “NEW COIL UP SAME DOWN” will be displayed; press the ‘–‘ button if it is the original atomizer, press the ’+’ button if a new atomizer has been installed.

NOTE: Please make sure the new atomizer is cold, otherwise the device will misread the atomizer resistance.

Output

Variable Output 5-200W / 100c-350C in Temp Mode

Construction

The Box is made in Steel & Glass

The Display

There is an OLED Screen

Battery Compatibility

The SnowWolf 200W takes 2 x 18650 batteries, It has built in short circuit & reverse polarity protection.

Battery Safety Please Read

IMPORTANT INFORMATION

By purchasing any batteries, devices, mods or kits that include batteries you are agreeing that you understand and agree with the following advice and that RedJuice (UK) cannot be held responsible for any damages arising from improper use or by not following the guidelines.

The Lithium batteries used in e-cig devices and mods need to and can output exceedingly high currents and can empty themselves VERY fast in a short circuit, with some cells this may result in overheating, rupture of the cell and possibly even explosion, always discard a damaged or suspect device or battery unless a competent engineer can repair or give it the all clear to use.

Guidelines

    1. NEVER leave batteries unattended when charging especially overnight while sleeping.
    2. NEVER keep batteries loose in your pocket or bag where they could short circuit and cause a dangerous or explosive event. Use a suitable case or plastic battery holder.
    3. NEVER place the charger on flammable surfaces when charging. (carpets, fabrics etc)
    4. Don't heat, incinerate or reverse the polarity, always check polarity when charging or inserting into the device.
    5. Do not over-charge or over-discharge. Remove from charge as soon as you get the green light or fully charged indication, check the instructions if unsure.
    6. Use only the correct charger for the batteries, if you are uncertain check.
    7. Only use recommended batteries and do not purchase or use cheap alternatives.
    8. Discard a battery if it fails to keep a charge or looks damaged in any way.
    9. Do not over-tighten atomisers / tanks onto the device, you only need to tighten until contact is made.
    10. When charging batteries via USB do not over-tighten them in the charging lead.
    11. Please dispose of batteries safely and according to the regulations.

E-Juice / E-Cigarette Safety Please Read

By purchasing any items from RedJuice (UK) you are agreeing that you understand and agree with the following advice and that RedJuice (UK) cannot be held responsible for any damages or health issues arising from improper use or by not seeking or following the guidelines or advice from medical professionals.

We make no claims that using an E-Cigarette will help you in giving up smoking cigarettes nor that there are any health benefits from giving up smoking cigarettes and using an electronic cigarette or device (simply put there is not enough evidence currently to support the idea) you need to make that decision for yourself. If you are unsure about the health risks or benefits involved in the switch or its suitability for you due to any conditions that you may have or you need help with nicotine dependency we recommend seeing a qualified medical practitioner for the correct advise.

Keep all devices, batteries and fluid totally out of reach of children, Nicotine in its pure form is a known poison and can cause serious harm. The levels of nicotine contained in E-Liquids if ingested (certainly by a small child) could cause serious harm and medical assistance should be sought immediately if suspected (taking the packaging with you to show the medical practitioner)

Age Restrictions

You must be eighteen (18) years of age, and possess a valid credit card to purchase any of our products. We absolutely reserve the right to cancel any sale based on our sole discretion where we reasonably believe or suspect the purchaser is purchasing products on behalf of a minor or is under the age of 18.

Selected Colour
Black
Device Output
USB Passthrough Ability
  • No
Variable Voltage
  • No
Variable Wattage
  • Yes
Max Output (Watts)
  • 200 Watts
Output Range (Ohms)
  • 0.05 - 2.5 Ohms
Tank Thread Compatibility
  • 510
Compatible With USB Output Adaptor
  • No
Device Stats
Coil Temperature Control
  • Yes (NI Coils Only)
Size
  • 101mm x 51mm x 25mm
Device Weight
  • 300g
Materials
  • Glass ,
  • Stainless Steel
Compatible Batteries
  • 18650
Protection
  • Reverse Polarity ,
  • Short Circuit
Display
  • OLED
Battery Life Display
  • Yes
Ohm Meter Display
  • Yes
Motion Sensor
  • No
Telescopic
  • No

No reviews found

Compatible With / See Also
 
  • Customers Also Bought
  • Recently Viewed