Top Filling! Unscrew and remove the top part and fill down the side of the glass avoiding getting any down the center of the coil.
To clean the tank part fill the unit with warm water, replace the top and shake vigorously. And then air dry the components, Aspire do not recommend that you clean the atomiser head or wicks so remove those first.
Empty the tank 1st then unscrew and remove the top part, Pull the glass from the base, once removed the atomiser head (Coil Unit) is located in the tank base unscrew and replace this part with a fresh head, do not over tighten, replace the glass on the base, Prime the coil and then allow a minute or two for the juice to soak into the wicks before firing to avoid getting a dry burn (damaging the wicks in the atomiser head)
Any 510 threaded mod capable of sub-ohm firing (see the above warning about sub-ohm usage)
Because of the consumable nature of the coils and for hygiene reasons we do not take back tanks or coils unless they are dead on arrival, You must inform us about this within 24 hours of delivery.
Buyers should beware of the many sellers of fakes and clones of devices and tanks made by Aspire, they will not have been through the same strict quality control or design process and may contain sub-standard materials, Aspire’s devices have been targeted hard but you can be assured as an authorised dealer we will only ever offer you genuine products that come directly from Aspire themselves.