Aspire Cleito Sub Ohm Tank
Important: This tank comes with the 2ml TPD Glass but, is compatible with all standard Cleito spares and drip tips.
Introducing the Cleito from Aspire. A sub ohm tank that is more than the sum of its parts. With an all new coil that replaces the standard chimney and delivers maximized airflow and vapor production.
- 1 x Aspire Cleito Sub Ohm Tank
- 1 x Spare Glass Part
- 4 x Coloured Rubber Cuffs
- 1 x Aspire Vape Band
- 1 x 0.2 Ohm Coil (55 - 70 Watts)
- 1 x 0.4 Ohm Coil (40 - 60 Watts)
At a glance
- Top Filling
- 2ml Pyrex Glass Tank Capacity.
- 52mm height
- 22mm width
- Stainless steel
How to fill
Top Filling! Unscrew and remove the top part and fill down the side of the glass avoiding getting any down the center of the coil.
To clean the tank part fill the unit with warm water, replace the top and shake vigorously. And then air dry the components, Aspire do not recommend that you clean the atomiser head or wicks so remove those first.
Replacing The Coils
Empty the tank 1st then unscrew and remove the top part, Pull the glass from the base, once removed the atomiser head (Coil Unit) is located in the tank base unscrew and replace this part with a fresh head, do not over tighten, replace the glass on the base, Prime the coil and then allow a minute or two for the juice to soak into the wicks before firing to avoid getting a dry burn (damaging the wicks in the atomiser head)
Any 510 threaded mod.
Because of the consumable nature of the coils and for hygiene reasons we do not take back tanks or coils unless they are dead on arrival, You must inform us about this within 24 hours of delivery.
- Stainless Steel
- Pyrex Glass
- Easy Top Filling
- User Replaceable Coils (Atomiser Head)
- 510 Thread
- Replaceable Drip Tip
- Bottom Vertical Coil
- Aspire Cleito
- 0.2 Ohm
- 0.4 Ohm
No posts found